Important Notice: On February 29th, this community was put into read-only mode. All existing posts will remain but customers are unable to add new posts or comment on existing. Please feel to join our Community Discord for any questions and discussions.

Cisco Fireampinstall?

Nelson Fernandez

January 26, 2017 17:13

I'm able to get PDQ Deploy to work with user logon but silenty using package settings never seem to work.

I checked Cisco's site and it looks like I'm doing it right. Any ideas?

Comments

3 comments

Marcel Lipovsky
January 29, 2017 20:40

There is sometimes a big difference in the specified switch depending on lower/upper case.
This might be the same problem. You are using /s in your example, while the documentation says /S.
Also I am not sure if its a good idea to run the installer as "Local system". I prefere to run the installer as administrator.

Try that out.

0
Nelson Fernandez
January 30, 2017 16:47

DUH!! thank you so much, that did the trick!

0
Marcel Lipovsky
January 30, 2017 16:57 (Edited January 30, 2017 16:59)

You are welcome!

And please vote for the solution as it may help others.

P.S.> Which one? /S or as Admin?

0