Important Notice: On February 29th, this community was put into read-only mode. All existing posts will remain but customers are unable to add new posts or comment on existing. Please feel to join our Community Discord for any questions and discussions.

Autodesk DWG TrueView 2013

Luca Cortese

June 26, 2012 10:48

Hello.

I've used the following switches to install DWG TrueView 2013:

/q /w /i setup.ini

Please remind it requires .NET Framework 4.0. The same switches seem to work also with Inventor View 2013 installation.

Bye,
Luca

Comments

4 comments

Gary Enticott
October 01, 2012 12:20

Doesnt work

0
Corellian, Shane
October 01, 2012 15:44

What error are you seeing Gary?

0
Matt Salo
December 07, 2012 14:18

I am using the same, but uppercase "/Q /W /I setup.ini". It's possible that the switches are case sensitive. Try them in uppercase.

Also, as the OP mention, make sure the machine you are deploying this to has .NET 4.0 installed, the install will fail if .NET 4.0 is not installed.

0
Nicolaj Kvist
June 20, 2016 12:21

\\cadserver\.....DWGTrueView_2017_Enu_64bit\setup.exe /Q /W /I setup.ini (works with both small and Capital letters) as a Command step works on both DWGTrueview 2017 and Inventor View 2017 and with normal succes codes: 0,1641,3010..Takes about 15 min to complete

0