1. PDQ Deploy & Inventory Help Center
  2. Community
  3. PDQ Inventory
 

Important Notice: On February 29th, this community was put into read-only mode. All existing posts will remain but customers are unable to add new posts or comment on existing. Please feel to join our Community Discord for any questions and discussions.

Dynamic Collection for Service Status

Avatar
Mike Kettle

Hi all. I'm trying to create a collection based on the status of two services. I would like the collection to contain only computers that have at least one of the services stopped. This is what I have set up:

The initial collection seems to work fine. The problem is when both of the services are started, the computers are not removed from the collection after they are scanned. What am I doing wrong here?

Thanks!

0

Comments

8 comments
Date Votes
  • Avatar
    Mike Kercher

    The status in PDQ Inventory would only change after the services are scanned again.

    0
  • Avatar
    Mike Kettle

    Correct, as stated above, the computers are not being removed from the collection even after the services are running and the computers have been scanned.

    0
  • Avatar
    Mike Kercher

    By chance, do you have more than one service that starts with Cisco?  

    0
  • Avatar
    Mike Kettle

    Yes, that's right. I am trying to filter the group based on two services. Again, this was stated in my original post.

    0
  • Avatar
    Mike Kercher

    You might try building two dynamic collections...one for each service explicitly.

    0
  • Avatar
    Mike Kercher

    Or add another Value Filter

    0
  • Avatar
    Colby Bouma

    Do the computers get removed if you refresh the console (F5)?

    0
  • Avatar
    Mike Kettle

    I figured it out, I was running the wrong scan. Need to run a standard scan to scan the services. Duh

    0